FIF Blog
FIF Blog
mobile logo How Do You Pressure New Bar Stool?

Assembly Tag

How Do You Pressure New Bar Stool?
August 13, 2026

How Do You Pressure New Bar Stool?

Pressure testing a new bar stool means confirming it carries weight evenly and safely before anyone sits on it at full height, and it takes about two minutes. This guide explains why the check matters more for bar seating than for any other chair in the house, and how careful assembly decides most of a stool's load bearing performance. You will find the test itself set out step by step, from pressing down on the centre and each edge of the seat to listening for the dry creak of a bolt that is not fully home, plus advice on seating a gas lift taper joint properly. We also cover how new foam settles over the first few weeks, checking height and footrest comfort under load, floor protection and stability, what to do when the test reveals a fault, and the six monthly checks that keep stools solid....

Continue Reading
How Do You Assemble Aldo Bar Stool?
August 12, 2026

How Do You Assemble Aldo Bar Stool?

Assembling an Aldo bar stool is a fifteen to twenty minute job that follows the same four stage sequence used by most gas lift designs. This guide covers laying out and identifying the parts, fixing the base plate to the column squarely, setting the footrest ring at the right height, orientating the mounting plate correctly on the seat, and pressing the taper joint home so the stool feels solid from the first sitting. It also explains how to test the gas lift and swivel, diagnose the wobble and angled seat problems that most often occur, match a set of stools to a consistent height, and care for the chrome column afterwards....

Continue Reading
How Do You Assemble Adjustable Height Swivel Bar Stool?
August 11, 2026

How Do You Assemble Adjustable Height Swivel Bar Stool?

Assembling an adjustable height swivel bar stool follows the same order almost every time: base to column, column into collar, footrest onto the column, swivel plate to the seat underside, then seat onto the piston. This guide walks through each stage with the details that catch people out, including why the seat feels loose until someone sits on it, why the gas cylinder taper needs no bolt, and why the footrest must be positioned before the seat goes on. It also covers checking bolt lengths, leaving base fixings slack until final alignment, orientating the swivel plate so the lever does not catch knees, tightening in a diagonal pattern, and the routine checks that keep a swivel stool tight through years of daily kitchen use....

Continue Reading