FIF Blog
FIF Blog
mobile logo How Do You Fit Sliding Wardrobe Doors?

sliding wardrobes Tag

How Do You Fit Sliding Wardrobe Doors?
August 13, 2026

How Do You Fit Sliding Wardrobe Doors?

Sliding wardrobe doors are fitted by screwing the top track to a level header, positioning the bottom track directly beneath it, then engaging each door in the top track before locating the bottom guides. Adjuster screws at the base of each door then bring it plumb so the gaps read evenly. Almost every problem with sliding doors traces back to one cause: tracks that are not in the same vertical plane. This guide covers checking the opening at six points, fixing the top track into joists rather than plasterboard, dropping a plumb line for the bottom track, packing an uneven floor, and the correct lifting sequence for top hung and bottom roller systems. It also explains how to adjust for even gaps, finish the side scribes, keep the channels clean, and diagnose doors that judder, rattle or jump out of the track. A short FAQ covers track height, mirrored panels and adjusting rollers after fitting....

Continue Reading
How Do You Adjust Wardrobe Sliding Doors?
August 13, 2026

How Do You Adjust Wardrobe Sliding Doors?

Sliding wardrobe doors are adjusted at the roller mechanism, generally through a small access hole in the bottom edge of the door, and most alignment faults take about ten minutes to correct with one tool and a spirit level. This guide explains how to tell whether you have a bottom rolling or top hung system, how to read the symptoms before touching a screw, and how to make the adjustment in small quarter turn increments so the door ends up plumb with even gaps. It also covers cleaning tracks properly, why oil based lubricants make things worse, levelling the carcass when doors drift open on their own, and recognising when a worn roller or bowed panel needs replacing instead....

Continue Reading
How Do You Build a Sliding Wardrobe Frame?
August 13, 2026

How Do You Build a Sliding Wardrobe Frame?

Building a sliding wardrobe frame comes down to one principle: the top and bottom tracks must sit in the same vertical plane, parallel and level, or the doors will never run cleanly. This guide walks through the whole process for UK homes, starting with the choice between a freestanding carcass and a wall to wall build in an alcove. It covers measuring an opening that is not square, the depth needed for hangers to clear the doors, fixing the top track into joists rather than plasterboard, dropping a plumb line for the bottom track, closing the ends with scribed uprights, planning the interior layout before the doors go on, and adjusting the rollers so both doors hang flush. There is also practical guidance on the tools worth having to hand, the order in which to work so nothing has to be undone, and the situations where buying a matched track kit is a more sensible route than fabricating parts yourself....

Continue Reading
How Do You Remove Wardrobe Sliding Doors?
August 13, 2026

How Do You Remove Wardrobe Sliding Doors?

To remove wardrobe sliding doors, slide the panel to the middle, lift it to clear the rollers from the bottom guide, tilt the base towards you and lower the top out of the upper track. Most systems need no tools, because sliding doors are designed to be lifted in and out for cleaning and repair. This guide covers the removal sequence for both bottom rolling and top hung systems, how to use the roller adjustment screws when a panel will not lift clear, and what to check when a door refuses to come out: sagged tracks, clogged guides and loose fixings. We also explain how to store panels safely, how to refit and align them so they glide rather than catch, and why taking the doors off is often a good moment to reassess the storage inside. There is also guidance on doing the job single handed, since these panels are heavier than they look....

Continue Reading
How Deep Is a Wardrobe UK?
August 13, 2026

How Deep Is a Wardrobe UK?

The standard UK wardrobe depth of around 58cm to 60cm is not arbitrary: it is derived directly from the width of an adult coat hanger plus clearance at the back and front. This guide explains that arithmetic, then works through what happens when a room cannot accommodate it. It covers front facing rails for shallow units and their real capacity trade off, why sliding door wardrobes typically need 8cm to 12cm more external depth because the panels sit in front of the carcass, and how to tell whether a quoted depth is internal or external. There is practical detail on depth in genuinely tight British bedrooms, including circulation space, hinged door swing arcs, and the common problem of chimney breast alcoves that fall short of standard. It also explains how skirting boards quietly push a unit forward, why the panel diagonal matters more than the depth on a staircase, and when two slim wardrobes beat one deep one....

Continue Reading
How Do You Build Your Own Sliding Wardrobe?
August 13, 2026

How Do You Build Your Own Sliding Wardrobe?

Building your own sliding wardrobe comes down to accuracy in two places: a base track that is dead level and a head track fixed precisely above it. This guide takes you through the full sequence, from assessing a dipping ceiling and measuring an opening that is out of square to building a scribed timber liner that corrects the room rather than fighting it. It explains how to plan hanging and shelf zones around the fact that sliding panels only ever reveal half the interior, how to calculate panel width including the overlap your track system requires, and why doors should be ordered only once the frame is standing and the finished reveal can be measured. It covers fixing into joists and masonry rather than bare plasterboard, hanging top hung panels safely with two people, adjusting rollers until the edges run parallel, and the scribing, cornice and lighting details that make a home built wardrobe read as fitted....

Continue Reading
How Much Does It Cost to Replace Sliding Wardrobe Doors?
August 13, 2026

How Much Does It Cost to Replace Sliding Wardrobe Doors?

The cost of replacing sliding wardrobe doors depends on four things: the number of panels, the material, whether the existing track can be reused and who fits them. This guide explains each cost driver so you can read a quotation properly rather than relying on a single figure. We compare melamine, mirrored, coloured glass and timber panels, including the weight differences that affect roller and track requirements. There is a practical checklist for assessing whether your current track can stay, covering channel depth, panel thickness and wear in the aluminium. We also cover the costs people overlook: glass disposal, making good the frame edges and internal fit out. Finally we look at when replacing the whole wardrobe is more sensible than the doors alone, and what an itemised quotation should include so two prices can be compared fairly....

Continue Reading
How Much Should Sliding Wardrobe Doors Overlap?
August 13, 2026

How Much Should Sliding Wardrobe Doors Overlap?

Sliding wardrobe doors need a deliberate overlap where they meet, and getting that figure right is the difference between a wardrobe that closes cleanly and one that shows a permanent line of daylight down the middle. This guide gives the recommended range, explains the simple calculation for two and three panel openings, and sets out why the overlap exists in the first place given that sliding panels never sit in the same plane. It covers how to measure an opening properly in an older British property, what goes wrong when the overlap is too tight or too generous, why mirrored and glass fronts are the least forgiving of misalignment, and how much of the problem is actually track levelling rather than panel width. There is also practical advice on choosing between two and three doors, sliding against hinged, and a checklist to run through before ordering....

Continue Reading
How Do You Adjust Sliding Wardrobe Doors?
August 13, 2026

How Do You Adjust Sliding Wardrobe Doors?

A sliding wardrobe door that scrapes the track or leaves a wedge shaped gap at the top is almost always fixable in twenty minutes with a screwdriver. This guide explains how to diagnose the fault first, then how to adjust the bottom rollers in small increments to bring each door back to square. It also covers the problems that adjustment will not solve: debris in the bottom track, loose top guides, misplaced anti jump blocks and rollers that have simply worn flat. There is guidance on removing and refitting doors safely, the extra care mirrored panels need, the right lubricant to use, and a short maintenance routine that keeps a sliding system running smoothly year after year. We also look at how to tell a genuinely misaligned door from a frame that has settled out of square, which is the point at which adjustment can only ever partly compensate for the opening itself....

Continue Reading
Can You Change Sliding Wardrobe Doors to Hinged?
August 13, 2026

Can You Change Sliding Wardrobe Doors to Hinged?

Swapping sliding wardrobe doors for hinged ones is possible, but it depends on conditions worth checking before you buy a single hinge. This guide explains the practical reasons people want the change, from wanting to see the whole interior at once to reclaiming the internal depth that a track and overlapping panels consume. It then works through the structural assessment: whether the carcass has solid vertical stiles that can carry hinge plates, whether the board is thick enough to hold fixings, and what happens to the opening once the tracks are removed. Measuring and planning door sizes comes next, including swing clearance against a bed or radiator and how many leaves the opening needs, followed by removing the sliding system without damaging the surrounding panels, building or lining a frame to hang from, and adjusting the finished doors. It finishes with the cases where replacing the wardrobe is genuinely more economical....

Continue Reading