FIF Blog
FIF Blog
mobile logo How Do You Cover Round Bar Stools?

DIY Tag

How Do You Cover Round Bar Stools?
August 10, 2026

How Do You Cover Round Bar Stools?

Recovering a round bar stool is one of the more approachable upholstery jobs, provided you cut the fabric correctly and staple in the right order. This guide walks through removing the seat pad, measuring the circle you need, deciding whether to strip the old cover, and working in opposite pairs so the tension stays even. We also explain how to fan the surplus into small neat pleats, when to replace tired foam and add wadding, and how a simple elasticated slip cover compares with a proper recover. There is guidance on choosing hard wearing fabric for a busy UK kitchen, the mistakes that spoil a finish, and how to judge when a stool is beyond saving. We also cover seats that cannot be removed from the frame, the small finishing touches that make a recover look professional, and why recovering a whole set at once avoids mismatched dye lots in a row of seats....

Continue Reading
How Do You Cover Bar Stools?
August 10, 2026

How Do You Cover Bar Stools?

Covering a bar stool is one of the most satisfying small jobs in a home, and on a round drop in seat it takes under an hour with a screwdriver, a staple gun, scissors and about half a metre of fabric. This guide explains the difference between a washable slip cover and a permanent recover, and how the construction of your stool decides which route makes sense. You will find a full step by step method for removing the seat board, judging whether to strip the old fabric, replacing flattened foam, setting even tension with four opposing staples and folding neat pleats around the curves. There is guidance on choosing an upholstery weight fabric that survives kitchen life, a simple pattern for an elasticated cover, honest advice on when a stool is not worth recovering, and a short FAQ covering fabric quantities and finishing....

Continue Reading
Can You Cut off Bar Stool Legs?
August 10, 2026

Can You Cut off Bar Stool Legs?

Shortening a bar stool is a reasonable fix when a worktop turns out lower than expected, but success depends on the frame you are working with and the care you take marking out. Solid timber legs can be cut cleanly with a fine tooth saw, provided every leg loses exactly the same amount and the cut follows the original angle rather than sitting square to the floor. Gas lift columns, welded tubular bases and finely tapered metal legs are a different matter and should be left alone. This guide covers the tools worth gathering, how to mark from the foot rather than the seat, why masking tape prevents splintering, and how to correct a stool that rocks once the cuts are done. It also explains how to seal exposed end grain and when replacing the stools is the wiser route....

Continue Reading
How Do You Reupholster a Leather Bar Stool?
August 10, 2026

How Do You Reupholster a Leather Bar Stool?

Reupholstering a leather bar stool is a patient job rather than a skilled one, and a simple round seat can be finished in an afternoon. This guide takes you through the whole process: judging whether the frame is worth saving, the tools and materials that make the difference, removing the seat and stripping old staples without damaging the board, replacing tired foam and adding wadding for a soft crown, and cutting new leather or faux leather with the right margin. It explains the four staple method that sets tension across the whole seat, how to pleat corners and ease gathers on a round pad, and how to refit the base without stripping the screw holes. Care advice and the cases where recovering is not worth attempting are covered too....

Continue Reading