Space garden spike lights along a terrace roughly 1.5 to 3 metres apart, and set each one about 30cm to 60cm from the plant, wall or edge it is meant to light. Use the closer end of that range for narrow beams and low output fittings, and the wider end for broad beams and brighter lights. Keep the gaps equal along a straight terrace so the light reads as a deliberate rhythm rather than scattered points.
Those numbers are a starting point rather than a fixed rule, and the right spacing depends on what you are lighting and the effect you want. Below we explain how to arrive at the right gaps for your own garden, using fittings from our modern outdoor lighting UK collection and the wider modern lighting UK range as examples.
Spacing makes sense only once you know the job each fitting is doing. Along a terrace, spike lights usually serve one of four purposes:
Most terraces combine two or three of these. It helps to decide which matters most, because that sets the spacing for the main run. Feature lights can then be added individually.
Beam angle is the width of the cone of light. It has more influence on spacing than brightness does.
Narrow beams, around 15 to 25 degrees, throw a tall, tight column of light. They suit tall grasses, upright conifers and the trunks of small trees. Because each pool is narrow, lights need to sit closer together, often 1 to 1.5 metres apart, if you want them to read as a continuous line.
Medium beams, around 30 to 40 degrees, are the most versatile. They light shrubs and mixed planting well, and spacing of about 1.5 to 2.5 metres usually gives gentle overlap.
Wide beams, from about 45 to 60 degrees, spread light across broad, low planting and wall surfaces. They can sit 2.5 to 3 metres apart, sometimes further.
Many spike lights have an adjustable head but a fixed beam. Some come with interchangeable lenses, which is useful if you are not yet sure which effect you want.
How far a light sits from the plant or wall changes the effect as much as the gap between lights.
Placed close, around 20cm to 30cm from a wall, a spike light grazes the surface and reveals every ridge in stone, brick or render. Placed further back, at 50cm to 80cm, it lights the surface more flatly and evenly. For planting, a position just in front of the plant, angled up into the foliage, picks out leaf shape and casts soft shadows behind.
For trees, set the light slightly away from the trunk and angle it up into the canopy. Two lights either side of a larger tree give it more depth than one.
Here is a straightforward way to plan spacing on a straight terrace edge.
So a nine metre terrace edge with a target of 2 metres gives four or five gaps. Choosing four and placing lights at each end gives five fittings at 2.25 metre intervals. Mark the positions with canes or pegs and a string line to keep them straight.
On a formal or contemporary terrace with a straight edge, equal spacing looks crisp and architectural. It suits clipped hedging, repeated planting such as rows of lavender or box, and modern paving.
In a looser, naturalistic border, rigid spacing can feel at odds with the planting. Here it is better to place lights where the plants need them, then adjust slightly so no two gaps are wildly different. The aim is a sense of balance rather than a precise grid.
Either way, avoid lighting every plant. The shadow between pools of light gives a garden its depth at night. A bed lit end to end with no darkness tends to look flat.
Where a terrace sits above the lawn, the edge and any steps need to be clearly visible. Spike lights angled downwards, or low fittings with a hood, can light treads and the line of the edge without glare. One light at each side of a flight of steps, or one at the top and one at the bottom of a short run, is usually enough.
Keep these safety lights consistent in output. A step that is noticeably darker than the rest of the terrace is easy to miss.
Spike lights are commonly sold as low voltage kits, with a transformer, a main cable and connectors for each light. These are relatively easy to install and move, which makes them well suited to adjusting positions as plants grow. Mains spike lights give more power for larger gardens but need armoured cable or ducting and should be installed by a qualified electrician.
Check the maximum cable run and number of fittings for any kit. Plan the cable route along the back of the border where it can be hidden under mulch or bark and kept away from areas you dig.
For ground level fittings, choose an IP rating of at least IP65; IP67 is better in borders that hold water after heavy rain. Solid brass, copper and good quality powder coated aluminium all age well in soil.
Spacing calculations only go so far. Before pushing every spike firmly into the ground, connect the lights and look at them after dark from three places: the terrace itself, the house and the far end of the garden. Move fittings a little at a time until the pools of light sit comfortably together.
Look out for hot spots where two beams overlap too strongly, dark gaps that feel accidental and any light shining towards a window. Adjusting the angle of the head often solves these without moving the fitting.
A terrace edge lit in rhythm makes a strong backdrop for the space itself. Large planters placed between lights, or lit from a spike tucked behind them, extend the rhythm onto the terrace. Our modern garden planters and troughs UK work well for repeating planting along a long edge.
A bench facing out from the terrace becomes a place to enjoy the lit garden. Our modern garden benches UK include designs that suit both traditional stone terraces and contemporary porcelain.
Plants grow, and the right spacing in spring can look different by late summer. Check positions a couple of times a year and nudge fittings as needed. Clean lenses gently, as soil splash and algae dull the light. If you use solar spike lights, our look at solar garden lights in UK winters will help you set expectations for the darker months.
Fewer, well placed lights also make for a calmer garden. Our guide to garden lighting and light pollution in the UK covers how to light a garden attractively while keeping wildlife and neighbours in mind.
When you are ready to plan, our full range of outdoor lighting and garden furniture is available at Furniture in Fashion, with free delivery to most UK mainland postcodes.
Typically 1.5 to 3 metres apart. Use closer spacing for narrow beams and low output fittings, and wider spacing for broad beams.
Around 20cm to 30cm for a grazing effect that shows texture, or 50cm to 80cm for a flatter, more even wash.
No. Leaving some areas in shadow gives the garden depth and makes the lit plants stand out.
A medium beam of around 30 to 40 degrees suits most shrubs and mixed planting.
Yes. Low voltage kits in particular are designed to be repositioned, which is helpful as planting grows and changes.
For step lights in a pergola, a warm white of around 2700K to 3000K is…
Styling outdoor lights in a modern rustic home is about pairing simple, dark metal fittings…
Interior designers place cordless outdoor lamps in a front garden in the same way they…
Security lights can work on a contemporary pergola when they are treated as one layer…
To choose porch lights for a front door, start with the type of porch you…
PIR sensor lights and garden spike lights are both common in UK gardens, yet they…
This website uses cookies.