For most courtyard gardens, individual recessed decking lights only need around 10 to 50 lumens each. That is enough to mark the edge of the deck, show the line of a step and give a gentle glow underfoot without lighting up the whole courtyard. If you want the deck itself to be usable for dining, you add a separate layer of light at table height rather than turning up the deck lights.
Courtyards are enclosed by walls, which reflect light back into the space. That is good news, because it means you need less output than you might expect. Below we explain how to work out the right level for your deck, where to place each light and how decking lights fit within the wider range of modern outdoor lighting UK homes rely on.
Decking lights are only one layer of a courtyard scheme. Wall lights, a lamp on the table and perhaps an uplight in a planter all add to the overall effect, and the same thinking applies to any room in the house. If you are new to layering light, browsing our full modern lighting UK sale range shows how different fittings combine, from ceiling lights indoors to the low glow you want underfoot outside.
Lumens measure how much visible light a source gives off. Watts, which people often still think in, measure energy use. With LEDs, a small fitting can give a useful amount of light from very little power, so lumens are the figure to compare.
As a rough sense of scale, a candle gives off around 12 lumens. A typical indoor table lamp bulb might be several hundred. Decking lights sit at the very low end of that range because they are viewed from close up, in the dark, and their job is guidance rather than illumination.
These are general guides that suit most UK courtyard gardens. Your own space may need a little more or less depending on wall colour and how dark the surroundings are.
Notice that the decking lights themselves are the lowest output in the whole scheme. The overall brightness of a courtyard comes from layering these sources, not from any one fitting.
An open lawn absorbs light and disappears into darkness at the edges. A courtyard is different. Brick, render and fencing bounce light back, and the enclosed shape keeps it contained. A pale painted wall can make a small number of low output lights feel surprisingly bright.
This works against you if you overdo it. Bright deck lights in a white walled courtyard produce glare and harsh reflections, and they can shine straight into ground floor windows. Starting low and adding more if needed is far easier than living with a scheme that is too strong.
If the deck is mostly a route from the back door to a garden gate or shed, guidance lighting alone is enough. If you eat and sit there in the evenings, you will want deck lights for safety and a second layer for the table and seating.
Mark any steps, level changes, raised edges and corners on a simple sketch. These are where lights matter most. A deck that drops onto paving or gravel needs that edge clearly defined.
For edge marking, spacing recessed lights around 1 to 1.5 metres apart usually gives a clear, even line without looking like a runway. On steps, one light per riser, or one at each end of wider steps, is normally enough. Along a short courtyard deck you may only need six to ten small lights in total.
Dark composite or stained boards absorb more light than pale or weathered timber. If your deck is very dark, choose the upper end of each lumen range. Pale boards and light walls let you choose the lower end.
Two lights of the same lumen output can feel very different. Warm white light, around 2700K to 3000K, looks softer and more natural on timber and planting. Cool white, around 4000K and above, tends to look brighter and flatter, and can make a cosy courtyard feel like a car park. For most decking schemes, warm white is the calmer choice.
The deck lights should guide people safely to the seating, and then the seating area should have its own softer, closer light. A dining set in the centre of a courtyard deck works well with a rechargeable lamp on the table and perhaps a wall light behind. If you are planning the layout, our garden dining sets UK come in round and compact shapes that suit enclosed spaces.
Try not to place recessed lights directly under chair positions. They will be covered most of the time, and when chairs are moved they shine straight up into the eyes of whoever is sitting there. Keep them to the edges and routes.
For walls, adjustable outdoor modern spotlights UK can graze light up brickwork or pick out a climbing plant. In a courtyard, lighting one wall well is often more effective than lighting all four.
Most decking light kits run at low voltage from a transformer, which is safer around timber and easier to fit. They are usually installed as the deck is built or during a refurbishment, with cables running underneath the boards. Make sure the transformer is rated for the total number of lights and sited in a dry, ventilated spot.
Any new mains outdoor circuit, including a weatherproof socket for a transformer, should be installed by a qualified electrician. In England and Wales this work falls under Part P of the Building Regulations.
Lights set into a deck surface sit in standing water after rain, so look for IP67 or higher. This rating means the fitting can withstand temporary immersion. Step and wall lights in less exposed positions can be IP44 or IP65.
Check that deck lights are rated for foot traffic, and choose LED fittings that stay cool, especially where children or pets may touch them.
Courtyards are often overlooked by several windows. Low output deck lights are among the most neighbourly forms of garden lighting, because they point down and stay close to the ground. Problems usually come from bright uplights or floodlights. Our guide to garden lighting and light pollution in UK gardens covers simple ways to keep a scheme considerate, including timers and shielded fittings.
Picture a courtyard of about four by five metres with a timber deck, a step down from the kitchen door and a small dining table in the middle. A balanced scheme might include:
None of these is bright in isolation, yet together they make the courtyard safe to cross, pleasant to look at from the kitchen and comfortable to eat in.
Decking lights in a courtyard should whisper rather than shout. Aim for around 10 to 50 lumens per fitting, use warm white, place them on edges and steps rather than in the middle of the deck, and let walls, planting and table lamps provide the rest. You will end up with a space that feels calm and usable, rather than floodlit.
For outdoor dining, lounge furniture and lighting chosen to suit UK gardens, visit Furniture in Fashion, with free delivery to most UK mainland postcodes.
For recessed lights set into the boards of a small courtyard deck, 100 lumens each is usually more than you need and can cause glare. That level suits post lights or wall washers better.
Around 1 to 1.5 metres apart along an edge works for most decks. Steps usually need one light per riser or one at each end.
Warm white, around 2700K to 3000K, suits most courtyards because it looks natural on timber and planting and feels relaxed.
Yes, by lifting boards to run cable underneath, or by using surface mounted or riser lights. Low voltage kits are the simplest option for retrofitting.
Finish is one of the first things people notice about exterior lighting, yet it is…
Coach lights suit a Victorian terrace because they belong to the same era of design.…
The best opal glass bathroom lights for a minimalist look are simple flush ceiling fittings,…
The bulb shape that looks best in a PIR sensor light depends on the fitting…
Dusk to dawn lights switch themselves on as daylight fades and off again when morning…
A pendant light is one of the most effective ways to give a master en…
This website uses cookies.