Furniture in Fashion Blog
Furniture in Fashion Blog
Furniture in Fashion Blog
The reliable way to hang string lights over a patio is to fix anchor points at a consistent height, stretch a stainless steel guide wire between them and clip the lights to that wire. The wire carries the load, the lights simply follow it, and the result is a neat line with an even dip rather than a sagging cable. Aim for a finished height of around 2.2 to 2.7 metres so tall guests can stand comfortably beneath it.
That approach works whether you are lighting a small terrace or a long patio beside a family garden. Below we go through the planning, fixings and finishing touches step by step, with ideas drawn from our modern outdoor lighting UK collection and the wider modern lighting UK range.
Step one: choose a layout
Start with how the patio is used and where the light needs to fall. There are four layouts that suit most British gardens.
- Single span: one run from the house wall to a post or tree. Simple, effective over a narrow terrace or a table set against a wall.
- Parallel runs: two or three straight lines across the patio. Clean and contemporary, especially over a long dining table.
- Zigzag: lights cross back and forth between the house and a row of posts, creating a canopy effect. The most atmospheric option for medium and large patios.
- Perimeter: lights run around the edge of the space, framing it without crossing overhead. Useful where overhead fixings are difficult.
Sketch the patio on paper, mark the anchor points and measure each run. That gives you the total length needed and stops you buying too little or too much.
Step two: work out the anchor points
Every run needs a secure fixing at each end. On the house side, this is usually a stainless steel eye bolt or a screw eye fixed into brickwork or a timber fascia. On the far side, you have several choices.
Existing structures: a garden wall, a fence post set in concrete, a pergola or a sturdy tree can all serve. Trees should be mature and stable; use a padded strap rather than screwing into the trunk.
Dedicated posts: where nothing suitable exists, timber or metal posts give you full control. Square timber posts of at least 70mm to 100mm section, set firmly into the ground or bolted into heavy planters, are a common choice. Posts should be tall enough to bring the fixing point to your chosen height after allowing for the depth set into the ground.
Keep the anchor heights consistent. Lights strung between points at very different heights tend to look accidental rather than designed.
Step three: install a guide wire
This is the step most people skip, and the one that makes the biggest difference. String lights are not designed to carry their own weight over long spans, especially in wind. A guide wire takes that strain away from the cable and bulbs.
Use stainless steel wire rope, typically 2mm to 4mm thick, with a turnbuckle at one end so you can tension it. Fix the wire to the eye bolts with wire rope grips or a thimble and clamp. Tighten the turnbuckle until the wire is firm but not rigid; a slight give helps it ride out gusts.
For short runs under about four metres, many festoon sets can be hung without a wire, but a guide wire still keeps the line neater and more durable.
Step four: attach the lights
With the wire in place, clip the lights along it using cable ties, small carabiners or purpose made festoon clips. Fix the cable at regular intervals, roughly every 30cm to 50cm, or between each bulb holder. Let the wire set the line and avoid pulling the light cable tight.
A little dip in each span looks relaxed and natural. Around 5% to 10% of the span length is a good guide, so a five metre run might dip by 25cm to 50cm in the middle. Keep the dip consistent across every run for a tidy finish.
Step five: plan the power
String lights need a power source close to the start of the run. An outdoor weatherproof socket on the house wall is the neatest solution. If you do not have one, a qualified electrician can install one with appropriate protection.
Avoid trailing extension leads from an open window or door. They are a trip hazard, a weather risk and a common cause of failed connections. Plan where the plug and transformer will sit, keeping them off the ground and out of standing water, and route the cable along walls or under paving edges rather than across walkways.
Solar string lights are an alternative where power is hard to reach. They are simple to install, though output can dip noticeably in the darker months, so place the panel where it sees the most open sky.
Choosing the right string lights
Not all string lights are suited to permanent outdoor use. Look for:
- An IP rating of at least IP44, with IP65 preferable for lights left up all year.
- Shatterproof bulbs, which are safer over seating areas and far easier to live with.
- Connectable sets, so you can join runs from a single power point.
- A warm colour temperature, ideally 2200K to 2700K, for that soft, inviting glow.
- Dimmable or low output LEDs, which look more atmospheric and use less energy.
Bulb spacing affects the look. Closely spaced bulbs create a fuller canopy; wider spacing gives a lighter, more airy effect that suits smaller patios.
How many lights do you need
Add up the length of every run in your sketch, then add about 10% to allow for the dip and for reaching the socket. A small patio with a single zigzag of four crossings might need 15 to 20 metres. A long patio with parallel runs could need considerably more. Check the maximum number of sets that can be connected end to end, as this varies between products.
Pairing lights with patio furniture
String lights look their best when they frame a destination, and on most patios that destination is a table. Centre the main runs over your dining area so the light falls where people gather. Our modern garden dining sets UK are designed with that kind of evening use in mind.
Parasols and lights can work together. Run the lights higher than the open canopy or position the parasol to one side so it does not catch the cable. A cantilever design from our modern garden parasols UK range keeps the pole away from the table and is easier to arrange around overhead lighting.
Common mistakes to avoid
A few errors come up again and again. The first is fixing lights directly to gutters or downpipes, which are not designed to carry a load and can be damaged as the wire tightens. Use the brickwork or the fascia board instead, and make sure fixings go into solid material rather than crumbling mortar.
The second is hanging lights too low. A line that looks generous during installation can feel oppressive once people stand and move beneath it, and low bulbs are easy to knock. Check the height with a tall member of the household before tightening everything.
The third is ignoring the view from inside. String lights should look good from the kitchen or living room as well as from the patio itself, so step indoors and look out before you commit to the final layout. A small shift in anchor points can make the display feel far more balanced through the window.
Being a considerate neighbour
String lights are gentle by nature, but a large display left on all night can still be noticeable from neighbouring gardens and bedrooms. A timer that switches them off at a reasonable hour, combined with warm, low output bulbs, keeps everyone happy. Our guide to light pollution and garden lighting in the UK sets out simple ways to enjoy lighting without affecting others or local wildlife.
Looking after the lights through the year
Check the guide wire tension and fixings each spring and autumn, as timber posts can move slightly as the ground dries and soaks. In very strong winds, it is worth unclipping the lights and storing them indoors. Wipe bulbs occasionally to keep the glow bright, and replace any cracked holders promptly. If you are using solar sets, our look at solar garden lights and their winter performance in the UK explains what to expect as the days shorten.
A well hung set of festoons can turn an ordinary patio into a space you use long after sunset. For lighting, dining sets and parasols in one place, take a look around Furniture in Fashion, where we provide free delivery to most UK mainland postcodes.
Questions about hanging patio string lights
How high should string lights be over a patio?
Around 2.2 to 2.7 metres works for most patios. It clears the heads of standing guests and keeps the light close enough to feel intimate.
Do I need a guide wire for festoon lights?
For spans longer than about four metres, yes. A guide wire carries the weight, protects the cable and keeps the lights steady in wind.
Can I leave outdoor string lights up all winter?
Lights rated IP65 with shatterproof bulbs are usually fine left up, but take them down during storms and check fixings regularly.
What can I attach string lights to if I have no trees?
Timber or metal posts set in the ground or in heavy planters, fence posts set in concrete and pergola frames all make reliable anchor points.

No Comments
Sorry, the comment form is closed at this time.