Furniture in Fashion Blog
Furniture in Fashion Blog
Furniture in Fashion Blog
To style outdoor security lights in a bungalow back garden, choose compact, well shielded fittings rather than bulky floodlights, mount them under the eaves so they point down and inward, and treat them as part of the overall lighting scheme rather than a separate add on. Because bungalow eaves are low, the light sits closer to the ground and closer to your neighbours, so a softer, warmer output and careful aiming matter more than raw brightness.
Done well, security lighting on a bungalow can look as considered as any decorative fitting. Our modern outdoor security lights UK selection includes slim, architectural designs, and they sit within our wider modern lighting UK sale range, which makes it easier to match finishes across the house. Below we look at the particular challenges of a single storey home and how to light the back garden so it feels both safe and pleasant.
Why Bungalows Need a Different Approach
Most security lighting advice assumes a two storey house, where a fitting placed high on the wall can cover a large area from above. A bungalow changes several things:
- Lower mounting height. The eaves are usually only a little above head height, so each light covers a smaller area and is more visible.
- Greater glare risk. A light at a low height shines more directly into eyes, both yours and your neighbours’.
- Easier reach. Low fittings can be tampered with, so robust, tamper resistant designs make sense.
- Wider plots. Many bungalows sit on wider, shallower plots with long rear elevations, which means more ground to cover along the back of the house.
- Daily use. Bungalows are often chosen for step free living, so lighting paths, patios and level changes safely is as important as deterring intruders.
Start by Mapping the Garden
Walk around the back garden after dark and note where you actually need light. For most bungalows, the list looks something like this:
- The back door and any patio doors.
- The route to the bins, shed or garage.
- The side gate and side passage.
- The patio or seating area.
- Any steps, ramps or changes in level.
- Dark corners near the boundary.
Group these into zones. A typical bungalow might have three: the main patio, the side access and the far end of the garden. Each zone can have its own type of light and its own sensor setting.
Choosing Fittings that Look Good
Avoid the oversized floodlight
The traditional halogen style floodlight was designed to throw a lot of light a long way. Mounted on a bungalow, it often produces harsh glare, deep shadows and a lot of light in the wrong places. Modern LED fittings are far more compact and allow much better control.
Wall lights with built in sensors
For most bungalows, the most elegant solution is a decorative wall light with an integrated PIR sensor. It looks like a normal outdoor wall light during the day, provides gentle ambient light in the evening if you wish, and brightens when it detects movement. Cylinders, cubes and simple lanterns all come in sensor versions.
Slim LED floods where coverage matters
Where you genuinely need wider coverage, such as a long driveway or a large lawn, choose a slim LED flood with an adjustable head. Angle it downward so the beam stays within your garden. A black or graphite body will be less conspicuous against the soffit.
Low level lighting
Bollards and spike lights along paths reduce the need for very bright fittings on the house. Guiding light at ground level makes walking safer and can be left on a timer during the evening.
Placement Under Low Eaves
- Mount under the soffit or just below it. This uses the maximum available height and shields the fitting from rain.
- Point down and inward. Light should fall on your patio and paths, not across the fence.
- Space fittings evenly. Two or three modest lights along a long rear elevation create far fewer shadows than one bright light in the middle.
- Keep sensors clear of hedges and trees. Moving branches can trigger lights repeatedly.
- Avoid pointing sensors at the road or a neighbour’s garden. Passing cars and pets next door can cause constant triggering.
Thinking About Neighbours
Bungalows are often in quiet residential streets, and back gardens are frequently overlooked by surrounding houses. Security lighting that floods a neighbour’s bedroom window every time a cat walks past is a common cause of friction.
Choose warm white light, keep brightness moderate and use shielded fittings that direct light downward. Setting a short sensor timer means the light switches off quickly once movement stops.
Boundaries play a part too. Well chosen modern garden fencing and screens UK can block light spill toward neighbouring properties while also giving you more privacy in the garden. Screens near a seating area also create a surface for soft, decorative light to fall on, which looks far more attractive than an empty dark space.
Combining Security and Ambient Light
The most successful bungalow gardens blend two layers of light:
- Ambient lighting for evenings outside: wall lights at a low level, lanterns on the patio, uplights in planting.
- Security lighting that switches on with movement when the garden is not in use.
Some sensor wall lights offer a dual mode, glowing softly from dusk and switching to full brightness when motion is detected. This gives a lived in look, which can be a deterrent on its own, without the stark on and off effect of a traditional security light.
Our article on how UK homeowners use outdoor lighting for security explores the balance between deterrence and comfort in more detail.
Practical Specifications
| Feature | Recommendation for a bungalow |
|---|---|
| IP rating | IP44 under a deep soffit, IP65 for exposed walls |
| Colour temperature | Warm white, around 3000K |
| Sensor range | Adjustable, so it can be reduced for small gardens |
| Timer | Adjustable from short to longer intervals |
| Body | Die cast aluminium or stainless steel for durability |
| Fixings | Tamper resistant screws where reachable |
Mains security lighting should be installed by a qualified electrician. Where possible, wire security lights to an indoor switch as well as a sensor, so you can override them when needed.
Styling Tips for a Cohesive Look
- Match finishes to window frames. White uPVC frames suit white or silver fittings; anthracite or black frames suit black or graphite.
- Use the same family of fittings. If the patio wall lights are cylinders, choose cylinder sensor lights for the side passage too.
- Light surfaces, not just space. A softly lit fence, wall or planted bed looks better and feels safer than a bright, featureless lawn.
- Keep the shed and side gate in view. These are the areas most worth lighting from a security perspective, and they can be lit with small, discreet fittings.
Privacy and the Bigger Picture
Security and privacy are closely linked. A garden that feels sheltered tends to be one you use more, and one you use more is one that feels safer. Our research into garden privacy and screening in UK homes looks at how people deal with being overlooked, which is often a particular concern in bungalow gardens surrounded by taller houses.
Lighting for Step Free Living
Many people choose a bungalow so they can live on one level, and the garden should support that just as well as the house. Good security lighting also makes everyday movement safer, particularly for anyone with reduced mobility or eyesight that struggles in low light.
Light ramps and thresholds evenly. A sensor light that comes on the moment someone opens the back door avoids the risk of stepping out into darkness. Where there is a slight drop from the door to the patio, a low level light beside the threshold makes the edge clear.
Avoid strong contrast. A very bright light next to a very dark area makes it harder for eyes to adjust, which can be disorientating. Several gentle sources spread along a path are far more comfortable than one powerful fitting.
Think about switches as well as sensors. A clearly marked switch just inside the back door, at a comfortable height, lets you turn on the garden lights before stepping outside. Illuminated switches are easy to find in the dark.
Finally, light the routes used most often: back door to bins, back door to shed, and back door to the washing line. Those short trips happen in all weathers and at all hours, and a well lit route makes them easier for everyone in the household.
A Calm, Safe Garden
Security lighting on a bungalow works best when it is modest, carefully aimed and designed as part of the garden rather than bolted on as an afterthought. Choose compact sensor fittings, mount them under the eaves, point them inward and support them with gentle low level light. You can browse outdoor lighting, garden furniture and screening together at Furniture in Fashion.
Frequently Asked Questions
How high should security lights be on a bungalow?
Mount them as high as the eaves allow, typically just under the soffit. Angle them downward to reduce glare at this lower height.
Can a decorative wall light work as a security light?
Yes. Many decorative outdoor wall lights are available with built in PIR sensors, giving you security lighting that looks like an ordinary fitting.
How do I stop security lights triggering constantly?
Reduce the sensor range, angle it away from roads and neighbouring gardens, and keep it clear of moving branches. A shorter timer setting also helps.
What colour light is best for security lighting?
Warm or neutral white, around 3000K, gives good visibility while feeling less harsh than cool white. It is also kinder to neighbours and wildlife.

No Comments
Sorry, the comment form is closed at this time.