An American queen size bed measures 152cm by 203cm, which is 60in by 80in. There is no British queen size: the UK ladder runs single, small double, double, king and super king, and a bed sold as queen in Britain is almost always a UK king at 150cm by 200cm. In Australia, a queen measures 153cm by 203cm, which is close to the American size.
So if a listing offers a queen size bed in the UK, check the centimetres. If it says 150cm by 200cm, it is a UK king with an imported label. If it says 152cm by 203cm, it is a genuine American queen, and your British bedding will fit loosely.
Against a UK single at 90cm by 190cm, a queen is 62cm wider and 13cm longer. Against a small double at 120cm by 190cm, it is 32cm wider and 13cm longer. Against a UK double at 135cm by 190cm, it is 17cm wider and 13cm longer. Against a UK king at 150cm by 200cm, it is 2cm wider and 3cm longer. Against a UK super king at 180cm by 200cm, it is 28cm narrower and 3cm longer.
The important comparison is the king. The two sizes are so close that in practical terms a queen and a UK king are interchangeable for room planning. The differences only surface when you buy fitted sheets, where a few centimetres of pocket tension is enough to matter.
British bed sizing developed from imperial measurements and settled early on 3ft, 4ft, 4ft 6in, 5ft and 6ft widths. The metric conversions we use today, 90cm, 120cm, 135cm, 150cm and 180cm, are simply those imperial widths restated.
American sizing developed separately, and the queen was introduced as a size between the full and the king. Because it landed at 60in, almost exactly the same as the British 5ft king, the two systems ended up with near identical products under different names.
The practical consequence for British shoppers is that searching for a queen leads you to kings, and that is the correct outcome rather than a mistake. The gap in the British range is not between double and king, where a queen would sit; it is arguably the absence of anything between 135cm and 150cm at all.
Since the sizes are effectively the same, the room planning is identical. Take the frame at around 160cm wide and 212cm long, then add walkways. Sixty centimetres on each side you need to use, 60cm at the foot if you cross the end of the bed.
That gives a room around 2.8m by 2.8m as the practical minimum with two walkways, and 3m by 3.2m for a comfortable layout with bedside cabinets on both sides. In a room 2.4m wide, one side of the bed will sit against a wall.
Measure at two heights, since skirting boards and radiators reduce the usable width at floor level while window sills and boxed pipework intrude higher up. The narrowest measurement is the one that governs.
This is where the label difference causes real problems. British bedding is cut for 150cm by 200cm. On a genuine American queen at 152cm by 203cm, a UK king fitted sheet will be slightly tight, and with a deep mattress protector underneath it may pull off a corner during the night.
Duvets are more forgiving. A UK king duvet at around 225cm by 220cm overhangs a queen mattress generously, and the overhang is the point. Pillowcases are unaffected, since UK standard pillows at 50cm by 75cm are used with both.
If you own a genuine American queen mattress and struggle with fitted sheets, look for deep fitted sheets with strong elastication all round rather than just at the corners. They cope with the size mismatch far better.
At 150cm to 152cm wide, the bed becomes the visual centre of most bedrooms. Frame proportion matters more than at smaller sizes, because there is enough width that a badly proportioned headboard looks obviously wrong.
A headboard of moderate height, somewhere between 90cm and 120cm from the floor, balances a bed of this width in a standard ceiling height room. Very low headboards make the bed read as a wide slab, while very tall ones can overwhelm a room under 2.4m in ceiling height.
Material sets the mood. Upholstered frames soften a room and absorb sound, which suits hard floors. Our king size fabric beds UK sale range covers the queen equivalent size in fabric, from plain panels to deeper buttoned designs. If you prefer a lighter look, the king size leather beds UK options give a cleaner line and wipe down easily, which matters in a room where a dog sleeps.
A bed of this width takes most of one wall in a standard bedroom, so storage has to be planned rather than assumed. Ottoman lift bases and drawer divans convert the volume under the mattress into usable capacity, which is the most efficient answer in a room where a chest will not fit.
Bedside cabinets should stay in the 40cm to 45cm range so walkways remain usable. Set the cabinet top height close to the mattress surface: with a deep mattress that means a taller cabinet than you might expect. Measure the mattress top height before ordering.
Where the room can hold one more piece, a chest opposite the bed serves better than a second cabinet beside it, since drawers need pull out clearance that a narrow walkway cannot give. Our wooden chest of drawers UK sale range includes narrow units suited to rooms where the bed dominates.
A wardrobe is the last consideration. Sliding doors suit rooms where the bed sits close to the storage wall, because hinged doors need swing clearance a tight room may not offer. You can compare frames, cabinets and wardrobes across the whole range at Furniture in Fashion, with free delivery to most UK mainland postcodes and returns available up to 30 days.
Whatever the label says, ask for three figures before ordering: the mattress size in centimetres, the external frame dimensions and the mattress depth the frame supports. Those three numbers tell you whether the bed fits the room, whether your bedding fits the bed and whether the frame suits the mattress you want.
Names vary between markets and change over time. Centimetres do not, and buying by measurement removes the guesswork entirely.
An American queen measures 152cm by 203cm. An Australian queen is 153cm by 203cm. In the UK there is no standard queen, and beds sold as queen here are usually 150cm by 200cm kings.
Yes, considerably. A queen is 17cm wider and 13cm longer than a UK double at 135cm by 190cm.
Duvets and pillowcases cross over without trouble. Fitted sheets will sit slightly tight on a genuine American queen, so choose deep sheets with elastication all round.
Around 3m by 3.2m allows the frame plus walkways and bedside cabinets on both sides. A room 2.4m wide will require one side of the bed against a wall.
Buy a UK king. It is the British standard at this size, so frames, mattresses and bedding all match, whereas an imported queen leaves you working around a few centimetres of difference.
Most UK beds are either 190cm or 200cm long. Singles, small doubles and doubles measure…
A king bed in the UK has mattress dimensions of 150cm by 200cm, which is…
A standard size single bed in the UK has a mattress of 90cm by 190cm,…
A queen size bed is approximately 150cm by 200cm, which is 5ft by 6ft 7in…
Double beds are 190cm long in the UK, which is 6ft 3in, and that length…
There are four realistic ways to get rid of a bed: book a council bulky…
This website uses cookies.