To measure a room for a high gloss bedroom set you need three sets of numbers rather than one: the room dimensions, the delivery route into the room, and the clearances each piece needs to open and be used. Gloss furniture adds a fourth consideration, because reflective fronts exaggerate any wall that is out of true and any gap that is uneven. Work through the fifteen steps below with a tape measure, a pencil and a sheet of squared paper and you will avoid almost every common sizing mistake.
Allow around thirty minutes. It is far less time than arranging a return for a wardrobe that will not fit up the stairs.
Use a rigid metal tape rather than a fabric one, record everything in centimetres and write numbers down as you go. Older UK properties rarely have square rooms, so measure twice at different points and always plan using the smaller figure.
Measure each wall at floor level, then again at roughly waist height. Walls bow more often than people expect, particularly in Victorian and Edwardian homes. Note the shortest reading for each wall.
Take the height in at least two corners. If the figures differ, plan against the lowest. Tall gloss wardrobes are unforgiving when a ceiling slopes even slightly.
A wardrobe is assembled or tilted upright, so the diagonal of the unit must be less than your ceiling height. Measure the height you actually have, then check the product depth and height before ordering.
Record the doorway width, the height of the frame and the arc the door travels. Bedroom doors in newer UK homes are often only 76cm wide, which becomes the limiting figure for boxed flat pack panels.
Measure the narrowest point between the front door and the bedroom, including the stair turn, the landing width and any low bulkhead. Flat pack solves most of this, but pre assembled items need the full route checked.
Note the distance from the corner to the window, the width of the opening and the depth of the reveal. This tells you whether a chest can sit under the sill and how much wall remains for a wardrobe.
Measure the radiator width, height and its distance from each corner. Never plan to sit a gloss unit tight against a radiator, as prolonged heat can affect adhesives and finishes over time.
Mark every socket, aerial point and light switch on your plan. A chest of drawers pushed over the only socket beside the bed is a daily irritation.
Note skirting height and depth. Many case pieces sit slightly proud of the wall because of it, and a two centimetre gap is highly visible behind a reflective panel.
Fix the bed first, because it dictates everything else. A UK double is 135cm by 190cm, a king is 150cm by 200cm and a super king is 180cm by 200cm. Check whether the frame itself adds width beyond the mattress.
Leave 60cm to 70cm along each side of the bed for comfortable access. If only one side is usable, plan a single cabinet rather than forcing a pair.
Hinged doors need roughly the door width again as clear floor space. Sliding doors need almost none, which is why they suit narrow rooms. Compare both options against your plan before choosing from the sliding wardrobes UK sale and hinged ranges.
Deep drawers can extend 50cm or more. Measure that distance out from the wall and make sure it does not collide with the bed or the door swing. This is the step most often skipped when choosing a high gloss chest of drawers UK for a compact room.
Transfer your figures onto squared paper at a scale of one square to 10cm and cut out paper rectangles for each piece. Move them around. Five minutes of paper shuffling reveals problems a mental picture hides.
Stand where each gloss front will sit and note what it will reflect. A gloss wardrobe facing a window doubles the daylight in the room. One facing a lamp at eye level can produce glare at night, so shift the lamp or angle the unit.
Matt finishes hide a multitude of small errors. Gloss does the opposite. A reflective surface reads as a continuous plane, so any deviation in the wall behind it, any uneven shadow gap and any misaligned handle becomes obvious from across the room.
Three practical consequences follow. First, leave a deliberate and consistent gap between units rather than trying to push them tight together. Second, check floor level with a spirit level and expect to use the adjustable feet. Third, plan the position of each piece so that the main reflection is something pleasant, usually a window, a plain wall or a piece of art.
Small rooms of around nine to eleven square metres tend to work best with a sliding door wardrobe on the longest wall, a slim chest and wall mounted bedside shelves. In rooms of twelve to sixteen square metres you can usually run a full high gloss bedroom furniture UK arrangement with a pair of cabinets and a dressing table. Above that, the challenge shifts from fitting pieces in to keeping the room from feeling sparse, and a bench or an occasional chair earns its place.
Keep a single note on your phone with wall lengths, ceiling height, door width, narrowest route point and radiator positions. Having those figures to hand makes comparing product dimensions quick, whether you are looking at a single item or a complete set. At Furniture in Fashion every listing carries full dimensions, so a prepared measurement note turns a long browse into a short one.
Room measurements tell you whether furniture fits. Assembly measurements tell you whether it can be built. These are not the same thing, and the difference catches people out with tall gloss wardrobes in particular.
Before the delivery arrives, clear a working area roughly the size of the largest panel plus a metre on each side. Most flat pack case furniture is assembled flat on the floor and then raised, so you need the floor space temporarily even though the finished unit occupies far less.
Check three further figures. First, the height of the assembled carcase against the ceiling, allowing for carpet thickness. Second, the diagonal measurement of the unit, which must clear the ceiling as it tilts upright. Third, the distance from the wall to any fixed obstruction such as a chimney breast, since a wardrobe raised at an angle needs that clearance for a moment before it settles into position.
Gloss panels also need protecting during the build. Lay a blanket or the packaging beneath the panels rather than assembling directly on a hard floor, since a single grit particle will mark a reflective surface permanently.
Product dimensions are usually given as width by depth by height, and it is worth confirming which figure is which before comparing. A few details make a practical difference:
Write your room figures and the product figures side by side rather than trying to hold both in your head. Seeing them in a column makes an overlap obvious immediately.
Leave one to two centimetres at each side for adjustment and around 90cm of clear floor in front of hinged doors. Sliding doors need only walking space.
It is better not to. Leave a reasonable gap so heat is not directed against the panel, and avoid drying laundry on a radiator immediately beside the unit.
Use the adjustable feet fitted to most case furniture and check the unit with a spirit level before final assembly. Gloss fronts make a leaning carcase very obvious.
Yes. Flat pack boxes are long and heavy, so check the stair turn and landing width even though the assembled dimensions are larger.
It often suits small rooms well, because the reflective surface returns light and makes the space read as larger, provided the layout leaves clear floor between pieces.
Matt bedroom furniture is often the better long term buy, mainly because it disguises the…
Grey bedroom furniture is genuinely flexible, but the colours that suit it depend entirely on…
In a loft conversion the ceiling, not the floor area, decides which furniture will work.…
A bedroom reads as expensive because of proportion, consistency and clear surfaces rather than because…
Compact bedroom furniture is worth buying when the room genuinely cannot take full size pieces,…
A wardrobe is the least forgiving item in a bedroom, so it deserves a proper…
This website uses cookies.