You can paint almost any wardrobe, including melamine and laminate faced units, provided you clean the surface thoroughly, key it with abrasive paper, apply a suitable primer and then build the colour in thin coats. The finish depends almost entirely on preparation. Painting straight onto a shiny factory surface without priming will produce a coat that peels within weeks, whatever quality of paint you use.
Solid timber and painted MDF are the easiest surfaces to work with. Melamine, laminate and high gloss faces need a bonding primer designed for low absorption surfaces. Veneer sits between the two and needs a light touch when sanding so the thin face layer is not cut through.
Work out what you are painting before buying anything.
Solid timber feels warm, shows grain on the edges as well as the faces, and takes paint readily after sanding.
Veneer looks like timber but the grain stops abruptly at the edges, where a thin band of a different material is visible. Sand very lightly.
Melamine and laminate are printed foils over chipboard or MDF. The surface is uniform, slightly plastic to the touch, and needs a bonding primer.
High gloss lacquered fronts are the most demanding. They must be flattened thoroughly, then primed with a product intended for glossy substrates.
If you are unsure, look at an inside edge or the back of a door. The construction is usually obvious there.
Remove the doors and take off all handles, hinges and internal fittings. Painting doors flat on trestles gives a far better finish than painting them upright, because the paint cannot sag into runs.
Label the doors and their hinges as you take them off so everything goes back where it came from. Hinge plates are adjusted individually and swapping them creates alignment work later.
Empty the carcass and lay dust sheets. Open a window and keep the room ventilated throughout. If the unit cannot be moved, mask the wall and floor edges carefully.
Fill any chips or screw holes with a fine surface filler suited to the material, then sand flush once it has cured.
Grease is the most common cause of paint failure on furniture. Years of handling leave residue around handles and door edges that primer will not adhere to.
Wash every surface with sugar soap or a strong detergent solution, then rinse with clean water and let it dry fully. Do not skip the rinse, since detergent residue causes its own adhesion problems.
Now key the surface. Use 180 grit on timber and painted MDF, and 240 grit on veneer and laminate. You are not removing the finish, only taking the shine off so the primer has something to grip. On high gloss, work until the whole surface has an even matt appearance with no glossy patches left in the corners.
Vacuum the dust, then wipe with a tack cloth or a barely damp lint free cloth. Any dust left behind will show in the finished coat.
Primer is not optional on furniture. Choose it to suit the surface.
For timber and MDF, a general purpose water based furniture primer works well and dries quickly.
For melamine, laminate and high gloss, use a bonding primer or an adhesion promoting primer made for smooth non porous surfaces. These are formulated to grip where ordinary primer will not.
Apply one thin even coat and let it cure for the full time stated, not just until it feels dry. Curing and drying are different things, and rushing this stage is what causes paint to lift when the doors are handled later.
Sand lightly with 240 grit, dust off, then prime again on high gloss surfaces. Two thin primer coats on a difficult substrate is time well spent.
Use a paint intended for furniture or woodwork rather than a wall emulsion, which has no durability against handling.
Water based satin and eggshell finishes are the practical choice for bedroom furniture. They are low odour, dry quickly and hold up to daily use. Modern acrylic formulations no longer yellow the way older oil based paints did.
Chalk paint gives a matt, slightly textured finish and needs a wax or varnish topcoat to survive being touched. It suits a decorative piece more than a wardrobe in constant use.
Full gloss shows every imperfection in the preparation. It looks superb when the groundwork is right and unforgiving when it is not.
Consider the colour in context. A wardrobe painted to match the walls recedes and makes a small room feel larger. A contrasting colour makes the unit a deliberate feature, which works better when the rest of the room is restrained. If the piece you are considering painting is already tired or damaged, it may be worth comparing the cost against the wider choice in our range of modern wardrobes UK sale collections before committing a weekend to the job.
Thin coats, always. Two or three thin coats give a harder, smoother finish than one thick one and dry properly through their whole thickness.
Use a small foam or short pile roller on the flat areas and a good quality synthetic brush for edges, mouldings and panel details. Lay the paint on, then roll or brush it out in one direction and leave it alone. Overworking a water based paint as it starts to set is what leaves brush marks.
Allow full drying between coats and sand very lightly with 320 grit before the final coat if you want a really smooth surface.
Paint the doors flat, face up, and let them cure horizontally. Stand them up too early and the soft film will mark wherever it touches.
Paint is dry to the touch long before it is hard. Most water based furniture paints need several days to reach full hardness, and some need up to a fortnight.
Refit hinges and handles once the surface is firm, but treat the unit gently for the first week. Avoid pressing painted door edges together, and if two painted surfaces will meet, a strip of felt or a small self adhesive bumper prevents them sticking.
Do not put clothing back until the smell has gone completely. Fresh paint fumes will transfer to fabric in a closed cupboard.
A well prepared painted wardrobe will look excellent and last for years of normal use. Wear appears first at the door edges and around handles, which is why fitting handles is worthwhile even on a unit that previously had none.
Touching up is straightforward if you keep a small quantity of paint labelled with the date and the room.
Painting is also a good way to unify pieces bought at different times. A mixed bedroom can be brought together with a single colour across the wardrobe, chest and bedside units, and pairing that with a coordinating piece such as one from our modern bedside cabinets UK sale selection ties the scheme together neatly.
Where a unit is structurally sound but simply the wrong size, paint will not solve the underlying problem. In that case a replacement makes more sense, and the full bedroom range at Furniture in Fashion covers narrow rooms and wide walls alike, with matching options across our modern bedroom furniture sets UK collections.
Painting over grease is the most common failure, and no primer will save it.
Skipping the sanding stage on a glossy surface leaves the primer sitting on the shine with nothing to hold it.
Using wall emulsion produces a surface that marks the first time a sleeve brushes it.
Applying coats too thickly leaves a soft film that stays tacky for weeks and dents under pressure.
Rehanging doors before the paint has cured causes the edges to stick together and tear when opened.
Yes. Clean thoroughly with sugar soap, key the surface with 240 grit until the shine is gone, then use a bonding primer made for smooth non porous surfaces before applying two thin topcoats.
Yes on any surface with a sheen. You are not stripping the finish, only creating a key so the primer can grip. Sand veneer very lightly to avoid cutting through the face layer.
A water based satin or eggshell furniture paint. It is durable enough for daily handling, low in odour and dries quickly. Wall emulsion is not suitable.
Wait until the paint has cured and the smell has gone completely, which usually means several days and sometimes up to two weeks depending on the product and the ventilation.
Yes if you can. Painting flat on trestles avoids runs and gives a noticeably better finish. Label each door and its hinges so they return to the same position.
Making your own wardrobe can take three quite different forms, and choosing the right one…
Sliding door wardrobe prices in the UK fall into three brackets: ready made freestanding units…
Wardrobe smells come from three things acting together: moisture, still air and worn clothing in…
Bar stools can often be shortened, but only some types, and telling them apart is…
Cut down your wardrobe by emptying it completely, sorting by category rather than by shelf,…
Building a built in wardrobe follows a fixed order, and the two stages that decide…
This website uses cookies.